cat toys and equipment-sfyh.com

Flammability Testing Nailed Fixture GT-MB18

Flammability Testing Nailed Fixture mainly used to test the inflaming retarding performance for solid and soft toys according to ASTM standard.

EN Impact Test Table GT-M29

EN Impact Test Table Used for the impact testing in the situation that simulating the toy material.

45 Degree Automatic Flammability Tester GT-C32

45 Degree Automatic Flammability Tester To determine the burning characteristics of textiles under controlled conditions.

Children bed comprehensive tester GT-MF01

Children bed comprehensive tester is mainly used for crib comprehensive performance test.

The EN Drop Tester is to determine the toys fall on the floor through a certain height, fall in a certain number, then check whether the hazardous sharp points, hazardous sharp edges, hazardous small parts and hazardous driving mechanisms have become accessible.

ASTM Drop Tester GT-M35B

The ASTM Drop Tester is to determine the toys fall on the floor through a certain height, fall in a certain number, then check whether the hazardous sharp points, hazardous sharp edges, hazardous small parts and hazardousdriving mechanisms have become accessible.

Average Speed Tester GT-M30

This Average Speed Tester is mainly used to test the mobile speed of the electric ride-on toy, can evaluate the motor braking performance and the maximum design speed of a toy cars.

Kinetic Energy Tester GT-M18A

EN71 Part 1 Kinetic Energy Tester GT-M18A is used to detect the maximum kinetic energy generated by the fired bullets of projectile toys or the launched bows, thereby to determine whether the toy projectiles would harm the child.

Motor Horizontal Brake Performance Tester GT-M31

Motor Horizontal Brake Performance Tester is mainly used to test the motor brake performance of electric ride-on toys.

Surface Flash Tester GT-M20

Surface Flash Tester is used to test the flammability of pile fabrics and simulated fur fabrics ( except floor coverings).

Safety Tester Diameter Rod GT-MF03

Safety Tester Diameter Rodis used to determine whether the openings or pores on the children bed will cause children finger fall into or not. This kit contains a 5.33mm diameter rod and a 9.53mm diameter rod.

ASTM F1821 Wedge Block GT-MF04

ASTM F1821 Wedge Block is used to determine whether the openings or pores on the children bed will cause children body fall into or not.

2m/s Tester & Dynamic Strength Tester GT-M19

Dynamic Strength Tester is mainly used to test the dynamic strength of wheeled ride-on toys.

Bite Tester GT-M45

Bite Tester is used to test whether the toys has cracked after bite test.

Rattle Test Template GT-M46

Rattle Test Template is used to test whether toys or the parts of toys may cause choking or swallowing.

Noise Testing Stand GT-M60

EN 71 part 1 Noise Testing Stand is the test stand for noise meter.

Pen Cap Air Flow Tester GT-S06

Pen cap air flow tester mainly be used to test the safety of the caps for writing and marking instruments. Standards: ISO 11540, BS 7272-1, GB/T 24110.

Small Part Cylinder GT-MB03

Small Part Cylinder used to determine the potential hazards of suffocate, suction, swallow, etc, which results from the toys or other articles with small parts used for the children below 3 years old.

Ball Impact Tester GT-M28

Ball Impact Tester is used to test the impact resistance of all rigid toys.

ISO 8124-1 ASTM F963 EN 71-1 Sharp Edge Tester GT-MB01

Toy Safety Testing Sharp Edge Tester Determine that metal or glass edges on toys and other articles intended for use by children under 8 years of age, and such edges exposed in normal use or as a result of reasonably forseeable damage or abuse of such toys and articles, present a potential risk of injury by laceration or avulsion